The following entries are logged in SMSTS.log:Ġ1-13-2016 17:56:35.510 TSManager 2176 (0x880) Start executing an instruction. _SMSTSNexInstructionPointer to the Instruction Pointer assigned to this task._SMSTSCurrentActionName to Install Application.Task Sequence Manager sets the following global environment variables for the next instruction: These built-in variables are initialized before the Install Application step runs in the task sequence. The values for these variables are available throughout the whole task sequence. These built-in variables provide information about the environment where the task sequence is running. There are more components involved due to the nature of running a task sequence.Īs the task sequence progresses, it maintains the status of tasks and the associated execution status using task sequence environment variables. But they don't function exactly the same. They both use Configuration Manager compliance settings. Step 1: Task Sequence Manager parses the task sequence XML and begins the Install Application taskĪpplication installations in a task sequence have a lot in common with application installations outside of a task sequence. If a deployment type contains dependencies, the dependent deployment type is evaluated and installed as part of the Install Application step.Īpplication dependencies aren't supported for stand-alone media. Based on the results of this check, the application installs the applicable deployment type. When the Install Application step runs, the application checks the applicability of the requirement rules and detection method on the deployment types of the application. It can also be used to troubleshoot the installation of multiple applications based on a list. The Install Application step described in this article covers a single application install task. When this step is run, the application installation begins immediately without waiting for a policy polling interval. This step can install a set of specified applications, or a set of applications that are specified by a dynamic list of task sequence variables. The Install Application task sequence step installs applications as part of the overall task sequence. Original product version: Configuration Manager current branch, Microsoft System Center 2012 Configuration Manager, Microsoft System Center 2012 R2 Configuration Manager Original KB number: 18408 ![]() This guide assumes that the Configuration Manager environment has already been installed and configured. This guide helps you understand the Install Application task sequence step and troubleshoot common problems that may occur.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |